• 0531-88785270

  • 山东英旭环保科技有限公司
    全国咨询热线
联系我们
免费热线
0531-88785270
网址:www.sdyingxu.com
邮箱: yingxu1881@163.com
济南办事处地址:济南市高新区舜泰广场6号楼1502
厂区地址:山东商河经济开发区汇源街66号
当前位置:首页 > 公司动态 > 详细内容

保温砂浆材料施工流程和技巧

来源:http://www.sdyingxu.com/news/51.html 发布时间:2017-04-26
1.保温砂浆材料层固化干燥后,用手掌按不动表面,一般约5天,方可进行下一道工序施工.GPES保温板
1 thermal insulation mortar layer after curing and drying, with the palm according to the surface, usually about 5 days before the next working procedure
2.对于本项目保温层厚度为30mm的最好分二遍施工,第一遍施工厚度控制在15mm左右第二遍保温砂浆材料保温层施工厚度10mm左右,这样可以有效保证保温层厚度达到标准要求,又能保证保温层不产生空鼓和裂纹.
2 for the insulation layer thickness of this project is 30mm the best two times over the construction, construction control in 15mm about second times the thickness of insulation mortar construction of insulation layer thickness of about 10mm, which can effectively ensure the thickness of the insulation layer to meet the standard requirements, but also can ensure the insulation layer does not produce hollowing and cracks.
3.保温砂浆材料保温层施工最少分两遍施工,第一遍抹保温浆料厚度不宜超过15 mm,以防由于重力作用产生空鼓,间隔24小时,进行第二遍的施工.施工温度偏低时,间隔时间可延长至48h-72h.
3 thermal insulation mortar insulation layer construction of at least two times of construction, the first time with thermal insulation thickness should not exceed 15 mm, to prevent the hollowing due to gravity, an interval of 24 hours, second times of construction. The construction of the low temperature, the time interval can be extended to 48h-72h.
4.第一遍无保温砂浆材料施工时,要用力批刮,保证保温浆料与基层密实, 以保证浆料和墙体的有效粘结,浆料之间同样要压实,以防空鼓.施工宜自上而下进行.
Thermal insulation mortar construction 4 the first time, to force the scraping, ensure insulation slurry and basic dense, in order to ensure the effective bonding paste and the wall, between the same slurry to the compaction, the anti air drum. Construction should be from top to bottom.
5.最后一遍保温砂浆材料厚度留10mm左右为宜,施工时应达到贴饼、冲 筋的厚度,并用大杠搓平,使墙面的平整度达到要求.
5 the last time the thickness of the insulation mortar material is about 10mm or so, the construction should be affixed to the cake, the thickness of the ribs, and with a large bar flat, so that the flatness of the wall to meet the requirements
此文关键字